8/°crank Knock control, knock sensor Voltage/V (amplifier factor included) Cyl.1 Cyl.2 Cyl.3 Cyl.4 27 28 29 Knock control, knock sensor Voltage/V (amplifier factor included) Cyl.5 Cyl.6 Cyl.7 Cyl.8 RPM/min-1 Load/% Coolant temperature/☌ Result/Text: Test ON /Test OFF/ Sys.

6/°crank Knock Control (Always actual values) RPM/min-1 Load/% Retard Cyl. 4/°crank Knock Control (Always actual values) RPM/min-1 Load/% Retard Cyl. 2/°crank Knock Control (Always actual values) RPM/min-1 Load/% Retard Cyl. Please can you advise on which Advanced Measuring Values I should select to perform the same test, and expected results, on my 2013 1. 8/°crank Knock Control (Always actual values) RPM/min-1 Load/% Ignition angle retard Cyl. VCDS Serial number CID301473 I recently discovered an article indicating that it is possible to use VCDS to indicate amount of Timing Chain stretch using Measuring Blocks 208 and 209. 3/°crank Ignition angle retard Cyl.4/°crank Knock Control (Always actual values) Ignition angle retard Cyl. 12 Misfire recognition/Text:activated/locked 11 12 15 16 17 18 19 Groups 020 - 029: Knock Control 20 21 22 23 24 25 26 Knock Control (Always actual values) Ignition angle retard Cyl. 9 Misfire recognition/Text:activated/locked Load/%/ RPM/min-1 window misfire recognition (if no misfire recognized: 0 at all positions) Lower RPM/min-1 limit Upper RPM/min-1 limit Lower RPM/min-1 limit Upper RPM/min-1 limit Misfire recognition Counter Cyl.

6 Misfire recognition/Text:activated/locked Misfire recognition Counter Cyl.7 Counter Cyl. 3 Misfire recognition/Text:activated/locked Misfire recognition Counter Cyl.4 Counter Cyl. of crankshaft tooth at camshaft flank low->high 13 Block not defined Block not defined Block not defined Block not defined 14 Misfire recognition RPM/min-1 Load/% Misfire counter Misfire recognition/Text:activated/locked Misfire recognition Counter Cyl.1 Counter Cyl. Groups 001 - 009 General Engine Data 1a 1b 2a 2b 3a 3b 4 5 General Engine Data (2 bank systems) RPM/min-1 Coolant temperature/☌ Lambda control value Bank 1/% Lambda control value Bank 2/% General Engine Data (1 bank systems) RPM/min-1 Coolant temperature/☌ Lambda control value (Injection adjustment) Adjustment requirements for basic setting xxxxxxxx │││││││└Coolant temp.

Vcds o2s measuring blocks list